DMX512 48V RGBW Pixel LED Strip Addressable Long Distance 80 LEDs/m No Noticeable Dimming

This is a DMX 512 RGBW digital LED strip light, different from ordinary SPI pixel LED strip lights. Its signal protocol is parallel rather than series, which can prevent the failure of one light in the series connection from causing the entire system to fail.

Not sure whether to choose DMX or SPI? This comparison breaks down control, wiring, and best-use scenarios: DMX LED Strip vs SPI LED Strip.

The entire DMX LED light consists of 80 LED lights on a 10mm-wide PCB board measuring 1 meter in length. It comes with a 5-PIN signal connector and separate power lines at both ends. The cut lines allow you to shorten or extend it freely, as you wish.

With the support of the Artnet/DMX512 controller, the communication between the DMX LED light strips is completely synchronized. The DMX addresses need to be set through the DMX address encoder/controller. And a 48V DC power supply is required to operate this light.

By using a higher voltage for system planning, the common issues of brightness attenuation and color shift at the end during long-distance operation can be reduced to a lower level, making the entire line appear more “uniform”.

It can achieve rich RGB dynamic effects as well as output an independent white light channel. The white light is cleaner and does not have a grayish tint, which makes it suitable for projects that require “daily lighting + presentation effects”.

If you’re planning a pixel setup, this article explains the control flow from controller to strip: Addressable LED Strips and Addressable LED Controllers How to Control.